DC-PIL-01 — Autopilot — remotely switched supply

← Circuit Register · House-bank supply diagram

Owner-reported circuit purpose; electrical installation not independently surveyed. Owner-confirmed separate Autopilot supply circuit, but controlled together with House and Windlass by the one common remote switch SW-002. Breaker/fuse rating and downstream wiring unverified.

FieldRecord
CircuitDC-PIL-01
SourceBB-003 positive distribution
Function / destinationAutopilot distribution: NAC-3 and steering drive related equipment, protected subcircuits not yet allocated
Functional controlSW-002 common remote switch, simultaneously controlling Autopilot, House and Windlass; NOT independent remote isolation
Installed branch fuse / breakerOriginal ANL fusing installed per owner, precise branch allocation and nominal value not independently verified
Source protection / isolationUnknown; input connection to source and upstream protection not surveyed
Cable and return pathConductor size, route, overcurrent coordination, negative return through the BMV-712 system-side shunt terminal unverified

This circuit is a functional link, not evidence that a correctly rated protective device has been inspected. The service’s switching state, its fusing and its protective role are independent properties. The unswitched circuits remain live while the common SW-002 House/Autopilot/Windlass switch is OFF; do not interpret unswitched as unprotected.

Outstanding physical inspection

Identify the fitted circuit protective device and rating, branch/feeder conductor cross-section, its DC panel or load endpoint, correct negative return via the BMV-712 shunt, and the controlling hardware where relevant.

NMEA 2000 connection and separate operating power

Owner clarification, 6 November 2026: NAC-3 EQ-073 retains its separate autopilot operating-power feed; its connection to NMEA 2000 segment B is for network/data. This resolves the earlier blanket statement that all segment B devices were bus-powered. Detailed power wiring and protective-device allocation still require documentation.