EQ-058 — Vesper Marine VA159 VHF/AIS antenna

← Equipment Register · COM-frame overview

Status: Owner-confirmed Vesper Marine VA159 and continuous RF feeder. The owner confirms one uninterrupted white Ancor RG213 coax run, with no intermediate connectors or joints, from masthead antenna to Digital Yacht SPL2000. Estimated cable length: mast height + 3 m (not tape-measured). No SWR/VSWR readings are available. Both end terminations are soldered PL-259 connectors, owner-confirmed. The precise coax run length and measured RF performance remain unverified.

Identity and location

FieldValue
Equipment IDEQ-058
FunctionShared marine voice-VHF and AIS-band transmitting/receiving antenna
Owner’s descriptionMasthead-mounted Vesper VHF/AIS-band-compatible antenna
ManufacturerVesper Marine, owner-confirmed
Installed modelVesper Marine VA159 — owner-confirmed
Manufacturer product codeVA159
Physical locationMS-T — masthead
RF connectionOne continuous, unjointed length of Ancor Marine Grade RG213 white 50 Ω coax, VA159 masthead → inside mast → swan-neck pipe into deckhead → EQ-005 SPL2000; no intermediate connectors. SPL2000 branches to EQ-003 VHF and EQ-004 AIS.
Estimated coax lengthMast height + 3 m — owner estimate, not physically measured; precise mast-height datum to confirm
Coax end connectors2 × soldered PL-259, at VA159 antenna base and SPL2000 antenna input — owner-confirmed; mating connectors are SO-239 per manufacturer specifications
As-fitted SWR / VSWRNot measured / no readings available, owner-confirmed
Installation stateOwner-confirmed functional arrangement and cable route; technical RF installation not independently verified

Electrical and RF reference

Owner-confirmed cable and route: Ancor marine-grade white RG213 (50 Ω) coaxial cable, running inside the mast, entering the deckhead through a swan-neck pipe and continuing to the SPL2000. Ancor specifications: 10.3 mm nominal OD, 96% tinned-copper braid and 1.9 dB/100 ft at 100 MHz (catalogue reference, not measured on Ragtime). No intermediate connectors or joints (owner-confirmed). The owner estimates cable length = mast height + 3 m, not an actual cable measurement. Both end connectors are soldered PL-259s (owner-confirmed). Physical condition, solder-joint inspection and weatherproofing have not been independently checked; no SWR readings have been taken.

Ancor 2024 catalogue (PDF)

This is a shared RF antenna, not one of the three known fused COM-frame DC loads. No antenna-specific DC supply has been reported. Its manufacturer model, white Ancor RG213 cable type and general mast/swan-neck route are owner-confirmed; manufacturer-specified antenna gain and VSWR appear below. The precisely measured run length, connector condition and weatherproofing at both ends, antenna mounting condition and rated transmit power (not specified in the sources consulted) remain unverified. The two soldered PL-259 end connector types are owner-confirmed. No installed SWR/VSWR measurement has been performed or reported; published manufacturer VSWR is a product specification, not a boat measurement.

Installed model: Vesper Marine VA159 (owner-confirmed)

The owner identifies the installed antenna as the Vesper Marine VA159, designed for a shared marine VHF radio and AIS transponder. The following are published manufacturer-model specifications, not Ragtime measurements:

CharacteristicPublished VA159 information
DesignShared AIS and marine voice-VHF antenna
Centre frequency159 MHz
Intended band156–162 MHz (approximately 6 MHz bandwidth)
Published VSWRBelow 1.5:1 across 156–162 MHz
Antenna typeHalf-wave
Published gain3 dBi
Antenna form1.0 m replaceable 316 stainless-steel whip; ABS housing
ConnectionSO-239 base socket; detachable coax cable
MountingL-bracket; suitable for masthead mounting

Identification: VA159 is the confirmed installed model, distinct from Vesper’s AIS-only optimised VA162. The VA159 is explicitly specified for shared voice VHF and AIS service.

The Digital Yacht SPL2000 supports 156–163 MHz VHF/AIS frequency operation (splitter specification). This figure does not establish the exact antenna frequency response. AIS channels use approximately 162 MHz; check antenna match and standing-wave ratio there, as well as voice-VHF frequencies, when the antenna model and test method are known.

Antenna-specific installation manual: No separate VA159 installation manual PDF was verified. The linked Vesper catalogues provide the model’s original specifications but are not installation manuals.

Operational reception observations

  • Owner report: Following installation of the lower-attenuation Ancor RG213 feeder, reception improved markedly relative to the preceding arrangement.
  • Practical example: Ragtime has received Jersey Coastguard transmissions while in Weymouth Bay.
  • Evidence classification: Qualitative, owner-reported reception performance. The observation is consistent with a more effective antenna/feed system but does not establish the cable’s exact insertion loss, the transmission distance, a quantified sensitivity improvement or the antenna’s SWR. VHF propagation, transmitting-station characteristics, antenna height and other installation changes can all affect received signal strength.

Information requested from the owner

  1. Length estimate recorded: mast height + 3 m. Confirm the mast height reference/datum or actual cable length only if available; no tape measurement is claimed.
  2. SWR readings: none available; an optional future check at voice-VHF and AIS frequencies would help establish antenna/feedline health, but the reception observation is not an SWR test.
  3. Both end connectors identified as soldered PL-259s. When convenient, inspect their soldered terminations and weatherproofing, particularly at the masthead, and check the antenna mounting. No intermediate joints need surveying.

Record maintenance

  • Evidence: owner confirmed Vesper Marine VA159 model, masthead location and shared RF path to Digital Yacht SPL2000 (31 October 2026).
  • VA159 product specifications come from Vesper Marine product literature, not from measurements or a photographed as-fitted nameplate.
  • Ancor white RG213, mast/swan-neck/deckhead route, and one continuous cable without intermediate coaxial connectors/joints owner-confirmed, 31 October 2026.
  • Estimated cable length mast height + 3 m (owner estimate, no physical measurement); no SWR readings available.
  • Both coax end terminations explicitly confirmed as soldered PL-259 connectors by the owner; mating connectors correspond to the VA159 and SPL2000 manufacturer’s SO-239 specifications. Connector condition has not been independently inspected.
  • Owner reports markedly better reception after the low-loss coax installation, including receiving Jersey Coastguard in Weymouth Bay. Qualitative operational observation, not a calibrated RF measurement.