EQ-061 — Lewmar HX1 800 W windlass

← Equipment Register · Windlass power circuit · House DC distribution

Owner-confirmed installed model (1 November 2026): Lewmar HX1 800 W. This identifies Ragtime’s physical windlass, but does not certify its electrical wiring, gypsy size, chain compatibility, serial number or condition. The original 2025 DC panel design article also identifies an HX1.

Equipment and connections

FieldRecorded evidence
Equipment IDEQ-061
Manufacturer and modelLewmar HX1, 800 W, 12 V; owner-confirmed fitted
Installation locationForedeck, at the bow/anchor locker; exact physical mounting measurements not recorded
Source and power circuitDC-WIN-01, on the house-bank common remotely switched supply SW-002
Fitted circuit breaker70 A CB-006, owner-confirmed, not the previously misreported 80 A
Other distribution protectionOwner confirms ANL and battery-post fuses installed. The 2025 article specified 100 A ANL Windlass, which is a historical nominal specification until the fitted fuse marking is read
Windlass motor operationSeparate EQ-062 contactor, actuated by two switches on the foredeck, SW-003 and SW-004
Low-current controlsDC-WIN-02 is the functional command/control path; actual fuse, control cable, directional mapping and contactor coil wiring untraced
Motor supply and negative returnConductor cross-section, total circuit length, termination and actual BMV-712 system-side return not physically surveyed
Chain/gypsy and serviceGypsy and chain dimensions, clutch details, chain counter and maintenance history not yet recorded

Manufacturer reference, not an onboard measurement

Lewmar’s HX1 installation, operation and servicing manual — document 65140050, Issue 2 specifies for the HX1 800: nominal 800 W/12 V model, 60 A current at working load, a supplied 70 A breaker (part 68000240), and 25 mm² cable guidance for a 20 m complete positive-and-negative electrical loop. Its standard wiring diagram includes a contactor (part 68000939), 3 A control fuse and 1.5 mm² control wiring. These are manufacturer specifications; the owner’s current confirmation is specifically the HX1 800 W, the fitted 70 A breaker and separate contactor with two foredeck switches. Do not infer that the installed contactor, fuse, switch parts or cable sections match the published standard drawing without tracing.

Lewmar advises a suitable independent means of securing the rode at anchor; the windlass should not serve as a permanent chain stopper. See the manufacturer’s manual for operating and maintenance requirements.

Audit relationships and unanswered details

  • Power: House-bank source → common SW-002 → windlass circuit protection including CB-006 → EQ-062 contactor → EQ-061. This is a functional description, not an electrically traced exact sequence of the ANL fuse, switch and breaker.
  • Control: two separate foredeck switches SW-003 and SW-004 command the contactor, which controls the motor. Specific UP/DOWN allocation, switch part numbers, any extra control station and coil terminals are unverified.
  • Returns: negative connection back through the battery-monitor system side must be confirmed by tracing; no shunt bypass is asserted.

Record history

  • 1 November 2026: Owner confirms Ragtime has a Lewmar HX1 800 W and an installed 70 A windlass breaker, superseding the previous incorrect 80 A breaker in the audit.
  • 1 November 2026: Owner identifies separate contactor and two switches mounted on the foredeck; manufacturer and exact model of these installed accessories not yet identified.